29
opeRation
instRUctions
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster,
non-ferrous metals and fasteners (e.g. nails
and clamps) as well as for working on soft wall
tiles and for dry grinding of small surfaces. It is
especially suitable for working close to edges
and for flush cutting.
WARNING! Before working your tool
make sure that no power cords will be
damaged. Before mounting or replacing
application tools or accessories, pull the
power plug.This preventative safety measure
eliminates danger from accidentally starting
the power tool.
Do not touch the gear box after long working
time, because it could be hot.
1. MOUNTING ACCESSORIES
CAUTION:
For all work or when changing
application tools, always wear protective
gloves. Avoid danger of injury from the sharp
edges of the application tools. Application tools
can become very hot while working, presenting
danger of burns!
WARNING! To reduce the risk of injury,
do not let the Universal end cut blades
or any segment saw blades face back toward
the user’s hand.
- Loosen the fastening piece
Use the Allen Key to rotate the fastening piece
clockwise. (See Fig. A)
A
- Insert accessories
For the accessories with machine and most other
branded accessories, the fastening piece must
be completely removed to install accessory
(See Fig. B).
NOTE:
For the
Universal-Fit
TM
Accessory.
Insert the Accessory onto the
Universal-Fit
TM
Accessory Interface.(See Fig. C)
B
C
- Tighten the fastening piece
-
Use the Allen Key to rotate the fastening piece
counterclockwise until accessory is tightened
securely.(See Fig. D)
D
2. MOUNTING / CHANGING THE SANDING
SHEET (See Fig. E)
Align the sanding sheet and press it onto the
sanding pad by hand.
Firmly press the power tool with the sanding
sheet against a flat surface and briefly switch the
power tool on. This provides for good adhesion
and prevents premature wear.
If one point has become worn, pull off the
sanding sheet, turn it 120° and replace.
E