Rath SmartRescue 10, Руководство по установке и эксплуатации

Страница: 12 / 13

Appendix
Page 12
TB1 Relay
SmartRescue System Activation Relay
When an Emergency Phone has been activated, this relay
changes from NO to closed. It can be connected to an alarm
panel, strobe, or other notification means.
Programming SmartRescue Back to Default Settings
1. Hold down Red Disconnect and Sub-Master 1 buttons for 5 seconds
2. Release buttons (you will hear a confirmation tone)
3. Press Phone 2 button, then Red button, then Sub-Master 2 button, and then the Phone 5 button
4. Press Sub-Master 2 button, then Sub-Master 1 button (you will hear a confirmation tone)
Program Emergency Phones to Consolidator Mode (Elevator Industry Only)
Note: Consolidator Mode allows you to have up to ten SmartPhones on a single telephone line and toggle
between them from an outside call.
Programming Steps
a. Press Enter to get into program mode
b. Press 7, Enter
c. For Phone(s) 1-5 press *, 1-5
Example:
• For Phone 1: Press 7, Enter, *, 1
• For Phone 2: Press 7, Enter, *, 2
d. For Phone(s) 6-10 press #, 1-5
Example:
• For Phone 6: Press 7, Enter, #, 1
• For Phone 7: Press 7, Enter, #, 2
e. To exit program mode, press and hold Stop for 2-3 seconds until warble sound
f. Confirm operation by calling the phone number that phone(s) are installed on; all phones will answer
To speak to individual phones:
• For phones 1-5 press *1, *2, *3, *4, *5
• For phones 6-10 press #1, #2, #3, #4, #5
• To speak to all phones press *0