Carefully open the shipping box and remove contents. Inspect the phones for damage. If there is any damage, call
800-451-1460 immediately to arrange corrective action.
Page 3
Line Connection:
Connect a dedicated phone line to the RJ11 jack on the back of the 2400 Series phone board labeled TEL LINE
using one of the following recommended methods:
1.
Crimp the phone line on to the center pins of a standard RJ11 jack and plug into TEL LINE input on the back of
the 2400 Series phone.
2.
Connect the phone line to a female RJ11 jack then take the phone line cord provided with the 2400 Series phone
from the jack to the TEL LINE input on the 2400 series phone.
3.
Connect the phone line to a biscuit jack style connector. Screw the phone line onto red and green terminals on
the back of the biscuit jack. Take the phone line cord provided with the 2400 Series phone from the biscuit jack to
the TEL LINE input on the back of the 2400 Series phone.
RATH® phones use the center pins of the RJ11 (red and green) for the outside phone line. Phone is not polarity
sensitive.
Note:
Do not cut off the end of the phone line cord and splice the phone line directly onto the line cord.
It is recommended that the wiring used inside the traveling cable or horizontal cabling is a 20 - 22 AWG twisted
shielded pair with the shield grounded at the elevator controller end only. This will help reduce or eliminate any
possible interference.
The phone line can be checked through the 2400 Series phone by pressing the
ON/OFF
button on the keypad.
After pushing the
ON/OFF
button, the phone should have dial tone. Once the phone has dial tone, use the keypad
to dial a number. Verify that the call connects and has two-way communication. Press the
ON/OFF
button again
to end the call.
Getting Started
S15 PROGRAMMING
SWITCH
KEYPAD
PUSH
BUTTON
FRONT OF BOARD
BACK OF BOARD
SYSTEM
ACTIVATION
RELAY
TELEPHONE
LINE
MICROPHONE
LED
SPEAKER
TELCO Voltage:
48-52vdc on an analog line with at least 25mA of line current and valid dial tone. Line must be
dedicated for a 2400 Series phone.
System Requirements
