RASOR GRT86, Руководство по сборке и использованию

Страница: 10 / 16

12. BLADE SHARPENING AND SHARPENER ADJUSTMENT
The blade sharpening is carried out with the cutting
unit on, by lowering the proper lever “1” (see picture
7), until the cutting edge of the rotating blade is reached
and the external edge is sharpened.
Repeat this procedure 3-4 times, for 3-4 seconds.
To carry out a good sharpening, lower the lever
progressively “1” (see picture 7) by avoiding abrupt
movements and an extreme pressure on the lever itself,
in order to protect the emery wheel from wear or
damage. The sharpening procedure must be carried out
carefully in particular when a worn blade is replaced with
a new one. In this case, an extreme pressure on the
sharpening lever may damage the cutting profile of the
new blade, compromising its correct use. Therefore,
we suggest adjusting the emery wheel as follows, after
assembling a new blade on the cutting unit:
• Disconnect the device from the power supply;
• Manually lower the sharpener so that the emery comes into contact with the cutting
blade profile (see picture 7);
• By means of a screwdriver, loosen the screw “2” (see picture 8);
• Manually rotate the threaded bush “3” (see picture 8) bringing the emery and the blade
closer;
• Tighten the screw “2” (see picture 8) and sharpen the blade as previously described.
7
2
3
13. LUBRICATION
Every 3-4 working days it is necessary to lubricate the
pair of gears. To carry out this operation, remove the
protective plug “A” located on the motor support of the
cutting unit and fill it with lubricating grease Rasor. Screw
plug “A” again a few turns. Screw plug “A” a few turns
every 2-3 working days (see picture 9).
The blade must never be dirty with grease or oil.
9
WARNING
A
1
8
Enfocus Software - Customer Support
EN
26