RASOR FP861RC, Руководство пользователя

Страница: 8 / 16

EN
24
8. USE WARNINGS
We recommend following the indications below in order to always work in safety conditions.
• All the operations must be carried out complying strictly with the safety rules of the
country where the machine is to be installed.
•
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the pneumatic scissors.
•
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place. Therefore, the Customer assumes the responsibility to strictly follow all the rules
and regulations in force, as well as the special provisions in force in sport and public
installations the Customer declares to know after receiving all the relative necessary
information.
•
The pneumatic scissors work also without their safety protective device and
with protection guard lifted. This protective device must NEVER be removed.
•
Always check the resistance of the material to be cut and the kind of blade which is being
used.
• The Customer shall equip his own personnel with all the individual safety protections for
the execution of the works, as well as with the ones which might be prescribed by the
Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
•
Only one operator must use the pneumatic scissors always standing behind the guide
handle. Do not make any adjustment while the blade is working.
•
Always pay attention to the air hose position to prevent it from being cut or damaged
by the blade.
• It is allowed to assemble pneumatic scissors FP861RC on machines O.E.M. on condition
that their original structure is not modified. Otherwise, the intervention must be certified
by Rasor
®
.
•
The pneumatic scissors FP861RC are equipped with double safety push button, made
up of a lever and a pawl in the handle: the pawl prevents the start push button to be
activated accidentally, the lever enables the cutter. Never remove the pawl.
NOTE
The cutting blade protrudes from the bottom of the supporting foot as described in picture
3 on the following page. The materials to be cut must have a higher thickness than the real
cutting height. The maximum projection of the blade is 20mm.
9. RESIDUAL RISKS
10. USE
4
5
B
3
A
� The cutting blade can work even when the protective guard is disassembled.
Even though the pneumatic scissors are safe, operators must pay attention to preserve their
and other people’s safety.
To use the pneumatic scissors manually, proceed as follows:
1) Lay the roll to be cut on the table;
2) Position the selector knob “A” on the desired selector notch according to the thickness
of the material to be cut (3mm, 10mm or 20mm) (see picture 3);
3) Connect the air hose to the quick connection “B” (not supplied) (see picture 4);
4) Adjust the pressure gauge (option) on 6 bar;
5) Put the material on the roll cutting foot (see picture 4);
6) Push the starting lever after moving the safety device (see picture 5);
7) Push the pneumatic scissors in the desired direction, by keeping the handle pressed
to carry out the cut.
NOTE
The thrust on the pneumatic scissors must be as uniform as possible.
closed