RASOR FP861RC, Руководство пользователя

Страница: 11 / 16

EN
27
12. SHARPENER ADJUSTMENT
7
1
2
6
5
1
2
3
4
6
7
8
WARNING
13. LUBRIFICATION
The blade must never be dirty with grease or oil.
8
WARNING
A
11. AIR PRESSURE GAUGE (OPTION)
The pneumatic scissors must be necessarily fed with
lubricated air with a pressure of maximum 6 bar.
Rasor
®
offers a reduction unit filter with a pressure
gauge already calibrated with the quantity of oil to
be delivered as option.
The unit shown also in picture 6 is made up of:
1 - pressure reducer;
2 - valve to drain the condensate;
3 - drop-feed oiler unit;
4 - oil tank;
5 - pressure gauge;
6 - condensate tank;
7 - pipe fitting to connect the quick connection to
the network;
8 - pipe fitting to connect the quick connection to the scissor.
For the use and maintenance read the instruction sheet supplied with the filter.
After using the machine for some hours without
interruption, or if the machine cutting capacity
is reduced, it is necessary to sharpen the blade.
To carry out this operation, start the blade and
press sharpener “2” on the blade itself (by means
of push button “1”, as shown in picture 7) for
3-4 seconds. Repeat this operation 2-3 times.
The sharpener button can be used only if the transparent guard is completely lowered.
Every 3-4 working hours, it is necessary to lubricate the
gear pair. In order to carry out this operation, remove
protective plug “A” located on the head of the
pneumatic scissors and fill it with the grease supplied.
Screw plug “A” again a few turns. Screw plug “A” a few
turns every 2-3 working hours (see picture 8).
10
14. BLADE REPLACEMENT
9
2
1
3
D
A
B
C
12
M
3
L
1
I
11
E
F
G
H
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. In order to carry out this operation, use butterfly
key “1” and drift “3” locking the blade (shown in picture
9).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with the
Local Law of the Country where the
machine is to be used (use of personal
protection devices);
2) Remove front movable safety protection
“A” and the spring “B”, by unscrewing
the slotted screw “C” through the
proper screwdriver (not supplied by the
manufacturer) and by extracting the
two washers “D”, as shown in picture
10.
3) Remove the rear fixed safety
protection “E”, the spring “F” and the
ring “G” by unscrewing the slotted
screw “H” by means of the proper
screwdriver (not supplied by the
manufacturer), as shown in picture
11.
4) Insert drift “3” (see picture 12) in hole
“I” in order to lock the blade (the hole
on the blade must correspond to the
hole in the structure).
5) Use butterfly key “1” in order to
unscrew nut “L” and remove blade “M”
(see picture 12).
6) Replace the worn blade with the new
one “2”, being careful to center the
blade on the shaft, in the correct
position, and remember to assemble it
with sidee with the writing Rasor
positioned towards the external side
of the pneumatic scissors.
7) Assemble all the components again
and carry out some cutting and
sharpening tests.