EN
8
8. USE WARNINGS
We recommend following the indications below in order to always work in safety conditions.
·
All the operations must be carried out complying strictly with the safety rules of the
country where the device is to be installed.
·
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the cutting unit.
·
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place.
Therefore, the Customer assumes the responsibility to strictly follow all the rules and
regulations in force, as well as the special provisions in force in sport and public
installations the Customer declares to know after receiving all the relative necessary
information.
·
The cutting unit works also without its safety protective device. This
protective device must NEVER be removed.
·
Always check the resistance of the material to be cut and the kind of blade which is
being used.
·
The Customer shall equip his own personnel with all the individual safety protections
for the execution of the works, as well as with the ones which might be prescribed by
the Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
·
Do not make any adjustment while the blade is working or while the electric plug is
connected.
·
Always pay attention to the electric cable position to prevent it from being cut or
damaged by the blade.
·
It is allowed to assemble cutting unit DD120LC on machines O.E.M. on condition that
their original structure is not modified. Otherwise, the intervention must be certified by
Rasor
®
.
Firstly make sure that the lines are able to feed the cutting unit correcltly, in compliance with
the safety rules (for the feature required see par. 5).
We suggest installing a magnetothermic safety device before the cutting unit and check that
the ground circuit is effective.
Before working on the feeding cable pull the plug out. Check that electric connections and
protections correspond to the driving force and the plate data values (voltage and current),
required by the different electric circuits.
By referring to the CEI 11-27/1 standard all the works carried out by means of electric current
must be performed by a staff, who has been provided with all the devices required by the
above-mentioned standard.
For the works carried out under voltage, it is necessary that the employer certifies the suitability,
against formative processes. The cutting unit DD120LC is supplied with electric cable
connected to the connector block located beside the motor.
The user must connect the cutting unit to the mains (the cable complies with the CEI 20-22
III Standard). Never change the length of the cable supplied. If it is necessary, use a longer
cable and replace the one supplied.
WARNING
9. ELECTRIC CONNECTION
