Rasonic RSG-R38B, Руководство по эксплуатации

Страница: 26 / 34

– 24 – – 25 –
座
檯
式
蒸
氣
焗
爐
Freestanding
Steam
Grill
Oven
5. Operation Instruction
5.1 Water Tank installation
CAUTION! Make sure the water tank is installed correctly and filled with water before use. Follow the instructions
below to install:
1.
Pull out the water tank at the bottom bracket of the appliance horizontally.
2. Open the circle rubber lid and fill water to the maximum level. (Suggested to use distilled water or filtered
drinking water.)
CAUTION! To avoid overflowing, water should not exceed the water inlet of the tank.
3. Close the circle rubber lid, and insert the tank at the bottom bracket.
ATTENTION!
If the tank is running out of water, buzzer will “beep” and refill indicator ( ) will flash on display.
The operation will stop until the tank is filled with water. Follow step 1-3 and press [ ] button to
resume the operation.
5.2 Standby Mode
Once connected to the electricity, buzzer will “beep” for one time, all the buttons and icon on the display light up
for 1 second. Grill mode (
) on the display will light up and the arrow [ ] will point to Grill on the panel. Time
display will start to flash while indicator and oven light switch on, the appliance enters function selection mode.
If the appliance is left idle for 30 seconds, display will dim while time display will not flash, and the appliance will
turn to standby mode automatically. To switch off the appliance, user can press the [ ] button once to resume and
press the [ ] button for 3 seconds, buzzer will “beep” for one time and all the buttons and icon on the display
will go out.
If all the indicators on the display are switched off, turn on the appliance by long pressing the [ ] button for 3
seconds.
5.3 First Use
Before first use, operate the appliance empty to eliminate the smell of the brand new unit by the below procedures:
1. Under function selection mode, press [ ] button to select <Convection> mode [ ]. ( ) on the display will
light up and the arrow [ ] will point to Grill on the panel. Preset cooking time 30 minutes “00:30” will flash
on the display. (
ATTENTION! Remove all accessories and food trays before start.)
2. Set the cooking time to 15 minutes “00:15” by rotating the knob, and press the [Knob/Set] button to confirm.
Rotate the knob again to set the cooking temperature at 250
℃
, the operation will start after pressing the
[ ] button. ( Note: Smoke and smell may appear during operation, which is a normal phenomenon. The
problem will be improved after several times of use.)
3. Once finished, open the oven door and use the appliance again after cooling down.
5.4 Function Selection Mode
Under standby mode, press the [ ] button and buzzer will “beep” for one time, the appliance will change to
function selection mode. User can select different cooking modes in order by pressing the [ ] button. The chosen
cooking mode will start after pressing the [ ] button.
Example: Use <Convection Grill > function for 20 minutes (Upper heater: 220
℃ and Lower heater: 200 ℃ )
1. Under function selection mode, press the [ ] button to select <Convection Grill > mode [ ]. The arrow [ ]
will point to Grill on the panel and display will show preset cooking time 30 minutes “00:30”.
2. Rotate the knob in anti-clockwise to trim down the cooking time setting at 20 minutes “00:20” (Increase the
cooking time setting by rotating the knob in clockwise direction). Press the [Knob/Set] button to confirm, the
temperature of the upper and lower heaters will flash on the display at the same time. Press the [Knob/Set]
button once to set the temperature of the upper heater individually.
3. Rotate the knob in clockwise to increase the cooking temperature of the upper heater at 220
℃
. Press [Knob/Set]
button once and temperature of the lower heater will flash on display.
Shung Hing Stean Grill Oven 70411(M).indb 25 2020-05-12 10:18:33