Rascal R600 Scooter Owner’s Manual
EMC Part: 19271200 • Rev. 03 • 06/01/2003
22
Converting Between 3 & 4 Wheel Operation
The Model 600T and 600F to be easily converted to an indoor model by replacing the front section with
the Chair Front End of the Model 600C.
Conversion requires lifting the existing front end off and installing another front end (either 600C or 3-
wheel, 4-wheel versions). Those with limited upper body strength may want to consider removing the
seat, top cover, footplate, and/or batteries before proceeding. Disassembly of these components are
described in a subsequent section (see “
Disassembly and Re-Assembly
” starting on page 24).
Replacing Front End
Use the following to replace the existing front end (Model
600T/600F) with the Model 600C.
1.
Turn scooter “Off” and remove key from keyswitch to
prevent accidents.
2.
Use seat locking lever and swivel seat 90
°
(facing
side of scooter).
3.
Carefully stand scooter upright onto rear bumper, as
shown in Illustration 13.
Note:
You may require assistance to lift scooter upright.
Illustration 13 — Standing Scooter Upright
19271200/13
4.
Loosen wiring harness from Harness Guide and
disconnect at connector, as shown in Illustration 14.
Illustration 14 — Disconnecting Harness
QUICK
DISCONNECT
PIN
HARNESS
CONNECTION
19271200/14
HARNESS
GUIDE
