Dominion KX II-101-V2 Quick Setup Guide
5
QSG-KX2101V2-v3.6.0-0E-E
255-62-3058-00-RoHS
A
None
- for a static IP. Default selection.
Recommended
option.
If
None
is selected, you must manually specify the
network parameters by entering the Default Gateway.
Leaving the selection set to
None
-
Lets you set the network parameters since KX II-
101-V2 is part of your network infrastructure and
you most likely do not want its IP address to
change frequently.
Ensure redundant failover capabilities should the
primary Ethernet port or the switch/router to which
it is connected fail.
If a failure occurs, KX II-101-V2 fails over to the
secondary network port with the same IP address
so there is no interruption.
B
DHCP - with this option, the IP address is
automatically assigned by a DHCP server.
Dynamic Host Configuration Protocol is used by
networked computers (clients) to obtain unique IP
addresses and other parameters from a DHCP server.
Enter the Preferred DHCP Host Name if DHCP is
selected from the IP Auto Configuration drop-down.
Up to 63 characters.
Next, configure IPv6 and/or DNS settings.
Configure the IPv6 Settings
If using IPv6, enter or select the appropriate IPv6-specific
network settings in the IPv6 section.
1
Select the IPv6 checkbox to activate the fields in the
section and enable IPv6 on the device.
2
Select an IP Auto Configuration option - None or
Router Discovery.
Link-Local IP Address
This address is automatically assigned to the device. The
address is used for neighbor discovery or when no routers are
present.
Read-Only
Zone ID
Identifies the device the address is associated with.
Read-
Only
A
None
- for a static IP.
Default selection.
Recommended
option.
If
None
is selected, you must manually specify -
Global/Unique IP Address - this is the IP address
assigned to KX II-101-V2
Prefix Length - this is the number of bits used in
the IPv6 address
Gateway IP Address
See IPv4 for details on leaving the selection set to
None
