Raritan AUATC, Инструкция по установке и эксплуатации

Страница: 15 / 20

C
HAPTER
3: O
PERATING AN
ASCII D
EVICE WITH THE
AUATC T
ERMINAL
C
ONVERTER
7
Chapter 3: Operating an ASCII Device with the
AUATC Terminal Converter
This section describes how to access and operate an ACSII-based device with a PS/2 or Sun console (keyboard and
monitor) using the AUATC.
Screen Layout
The AUATC produces eight color, 800x600-resolution video, which can accommodate 32 lines of 80 text
characters. A typical ASCII terminal uses 24 lines, so the AUATC uses the 8 extra lines to provide system status and
help information. These 8 lines are located on the top four and the bottom four lines of the screen (see Figure 4).
•
Line 1, top window: AUATC firmware version is displayed to the right
•
Line 3, top window: Cursor position and buffer page number is displayed to the left; terminal type and baud rate
are displayed to the right
•
Line 4, top window: Communication status is displayed at the center. Status can be one of the following:
−
On Line : Communicating with computer. The terminal screen area displays the interactions with computer.
−
Help : Press < Alt-F1 > to display the AUATC Help screen.
−
Set Up : Press < Alt-F2 > or < Alt-F3 > to enter set-up mode.
−
Buffer Edit : Press < Alt-F4 > to enter buffer review/edit mode.
•
Line 4, top window: AUATC Access indicator is displayed on the right. It indicates one of the following:
−
LOC : Local port is active, either PS/2 keyboard or Sun keyboard
−
RMT : Remote port (RJ45) is active
−
NO : No port is active.
•
The 4 lines in bottom window display command keys specific to the current screen.