Rapid E-tac, Руководство пользователя

Страница: 5 / 85

8 9
TECHNICAL SPECIFICATION
Model Number E-tac
Voltage 220–240 V
~
, 50Hz
Current 1.8A
Brad Type, length Rapid T8/300, 15 mm
Staple Type, length Rapid 140 Staple 6, 8, 10, 12, 14 mm
Magazine Capacity 50 pcs (65 mm)
Speed 20 shots/min
Tool Weight 0.66 kg
NOISE EMISSION
A-weighted sound pressure level LpA=87.6 dB(A), uncertainty K=3 dB(A)
A-weighted sound power level LwA=98.6 dB(A), uncertainty K=3 dB(A)
Wear hearing protection.
VIBRATION
Vibration total value=2.8 m/s
2
, uncertainty K=1.5 m/s
2
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another
The declared vibration total value may also be used in a preliminary assessment of
exposure
The vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used.
ASSEMBLY
DEFINITIONS (FIGURE 1)
Trigger Switch
Power Cord
Magazine Latch
Staple output
On/Off Power Switch
Trigger Safety Lock
LOAD STAPLES/BRADS INTO THE MAGAZINE
1. Turn off the power switch and unplug the tacker
2. Hold tool upside down, squeeze latch and slide magazine open.
3. Put staples or brads in magazine, legs facing upward and close magazine
(Figure 2 or 3) Ensure brad strip stays upright in magazine.
Use only recommended staples or brads
4. Close magazine and make sure it is securely locked.
REMOVE STAPLES/BRADS FROM THE MAGAZINE
1. Turn off the power switch and unplug the tacker
2. Hold tool upside down, squeeze latch and pull out magazine.
3. Remove the staples / brads from the magazine
4. Close magazine.
OPERATION
STAPLING
1. Plug stapler into a 220-240V~, 50Hz power outlet.
2. Turn on the power switch (Figure 4) and release Trigger Safety Lock
3. Make sure the tool is in good working condition.
4. Hold the tacker firmly with the staple output flat against the work piece.
5. Squeeze Trigger to fire the tacker.
6. Unplug tacker, turn off Power switch and set Trigger Safety Lock after use
NOTE: For better performance press the tool against the work piece
(Figure 5)
NOTE: In case of jammed staple or brad, read the maintenance section.
DO NOT re-fire the tool in order to clear the jam as this may damage the tool.
NOTE: During operation, the tool may feel warm. This is normal but if the tool
starts to feel hot use shall be discontinued until it cools down.
NOTE: The tacker should be used only for the intended purposes. It is
designed for use on wood or similar materials in indoor environment
GUIDELINES FOR USING EXTENSION CORDS
Recommended Minimum Wire Area (mm
2
) for Extension Cords
Up to 10m: 1,5 mm 2 Up to-25m: 2,5mm 2 Over 25m: not suitable