2
Quick Start
English
3. Preparations, Operating Mode & Start
•
•
•
•
•
•
•
•
Put on protective gloves.
Grasp the handle of the lid and lift it upwards
until it locks into the open position. (Fig. 1)
Check the vacuum seal and the glass bottom for
any contamination. If necessary, clean the
machine‘s interior according to the prescribed
cleaning steps. (Fig. 2)
(See the cleaning instructions on page 3.)
Place the components to be cured on the glass
bottom. (Fig. 3)
(See the general information on page 1.)
Close the lid. (Fig. 4)
Select the operating mode by choosing either a
job, material or customer setting (if available).
Press the start button to start the curing process.
Wait until all process steps are finished. (Fig. 5)
After the curing process is finished, check the
components for the desired result. (Fig. 6)
Figure 6
Figure 5
Jobs
Material
Custom
D10+ capsule
2019-04-05 11:00 Upper Jaw Patient 1
D10+ capsule
2019-04-05 10:45 Upper Jaw Patient 2
D10+ capsule
2019-04-05 10:25 Upper Jaw Patient 3
Jobs
Material
Custom
D10+ capsule
2019-04-05 11:00 Upper Jaw Patient 1
D10+ capsule
2019-04-05 10:45 Upper Jaw Patient 2
D10+ capsule
2019-04-05 10:25 Upper Jaw Patient 3
Figure 4
Figure 1
Figure 3
Figure 2
