Operating instructions RS wash
│
D wash
│
P wash
│
SHERAprint wash
│
3Dewash
25
│
29
Rapid Shape GmbH
│
DOCR000257
3.
Disconnect the cleaning liquid container from the machine.
4.
Remove the lid of the container and place it upside down (tubes
facing upwards) on a flat surface.
5.
Slide the bottom of the container to the RFID reader again.
6.
Remove the rear (dirty) bottle and seal it with the lid kept in the
container. Set the bottle aside.
Then check if there are liquid residues on the bottom of the
container. Clean these with a paper towel.
7.
Remove the front (clean) bottle and place it in the rear position
of the container. Pay attention to the position markings on the
bottle and container. The RFID tag on the bottle is read.
8.
Open the new bottle of cleaning liquid. Place the bottle cap in
the appropriate storage compartment of the container base.
9.
Insert the new bottle in the front position of the container. Pay
attention to the position markings on the bottle and container.
The RFID tag on the bottle is read.
10.
Put the lid back on. Insert the tubes into the bottle openings.
When doing so, make sure that the container is not removed
from the RFID reader.
11.
Reconnect the container to the coupling connection of the
machine. The coupling must click in audibly.
12.
Finish the wizard on the user interface. Return to the Home
screen.
13.
Dispose of the used cleaning liquid.
NOTE!
Wearing protective gloves protects the skin from contact
with skin damaging materials. It is therefore essential to
observe the information provided by the material
manufacturer.
Dispose of used cleaning liquid according to local waste
disposal regulations. Please take note of the safety data
sheets of the respective materials.
8.2.2
Check and clean inner container
Required accessories:
Personnel:
Paper towel, isopropanol, protective gloves
Operator
For checking and cleaning the inner container, please proceed as
follows:
1.
Put on protective gloves.
2.
Open the drawer.
3.
Check the inner container for wear. In case of severe signs of
wear, the container can be changed. Separate installation
instructions are enclosed with the spare part.
4.
Check the inner container for soiling. Remove light soiling with a
paper towel moistened with isopropanol. For persistent soiling,
e.g. hard incrustations, the container can be replaced. Separate
installation instructions are enclosed with the spare part.
