Rapid Engineering CTHN-100, Руководство по установке и эксплуатации

Страница: 18 / 100

CTHN-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
12 of 91
SECTION 7: GENERAL SUSPENSION DETAILS
To ens u re yo u r safety and comply w ith the terms of
the w arranty, all u nits m u st be installed in
accordance w ith these instr u ctions.
The gas or the electrical s u pply lines m u st not be
u sed to s u pport the heater.
Do not locate the gas or electric s u pply lines directly
over the path of the fl u e prod u cts from the heater.
The heater m u st be installed in a location that is
readily accessible for servicing.
The heaters m
u st be installed in accordance w ith
clearances to comb u stibles as indicated on the rating
plate and in this instr u ction man u al.
The minim u m and maxim u m gas inlet press u res
m u st be maintained as indicated on the rating plate.
Typical installation config u rations are sho w n
on Page 13, Figure 14 .
Expansion and contraction of the t u be dictates that
the minim u m s u spension lengths m u st be
maintained. See table on Page 13, Figure 14.
WARNING
Severe Injury Hazard
Secure burner to burner tube with bolts and
lockwashers.
Han g heater with materials with a minimum
workin g load of 75 lbs (33 k g ).
Failure to follow these instructions can result
in death, injury or property dama
g e.
WARNING
Cut/Pinch Hazard
Wear protective g ear durin g installation,
operation and service.
Ed g es are sharp.
Failure to follow these instructions can result
in injury.