Rapid Engineering BH-40, Инструкция по установке, эксплуатации и обслуживанию

Страница: 55 / 68

SECTION 11: O
PERATION AND
M
AINTENANCE
49 of 59
Blower Scroll, Wheel and
Motor Compressed air or a v ac uu m cleaner may b e u sed to clean d u st and dirt.
Burner Cup and Orifice Clear of o b str u ctions (e v en spider w e b s w ill ca u se pro b lems).
Caref u lly remo v e any d u st and de b ris from the bu rner.
Electrode Replace if there are cracked ceramics, excessi v e car b on resid u e, or erosion
of the electrode.
The electrode gap sho u ld b e 1/8" (3.2 mm).
Thermostat There sho u ld b e no exposed w ire or damage to the thermostat.
See Page 43, Section 10 .
Suspension Points Make s u re the heater is hanging sec u rely. Look for signs of w ear on the chain
or ceiling.
See Page 15, Figure 14 .
Decorative and Protective
Grille (optional) The grille m u st b e sec u rely attached.
Check that the side reflector extensions are installed correctly and sec u red in
place if necessary. (Decorati v e grille only.)
See Page 32, Section 7.5 and Page 34, Section 7.6
Make s u re shield is installed correctly and sec u red in place if necessary.
(Decorati v e grille only.) See Page 33, Section 7.5.2 .
Lower Clearance Shield
(optional) The lo w er shield m u st b e sec u rely attached. Inspect shield s u pport straps
and lo w er clearance shield anchor points.
See Page 32, Section 7.4 .
Make s u re shield is installed correctly and sec u red in place if necessary.
See Page 32, Section 7.4 .
Wall Ta g If w all tag is present, make s u re it is legi b le and acc u rate. Please contact
Rapid Engineering LLC or yo u r RAPID
TM
independent distri bu tor, if yo u need a
w all tag. See Page 4, Section 2.1
Safety Labels Prod u ct safety signs or la b els sho u ld b e replaced b y the prod u ct u ser w hen
they are no longer legi b le. Please contact Rapid Engineering LLC or yo u r
RAPID
TM
independent distri bu tor to o b tain replacement signs or la b els. See
Page 2, Figure 1 through Page 3, Figure 2 .