25
INSTALLATION
Check the ap pli ance is electrically safe when you have fi nished.
front roller so that the front of the cooker is supported
on the feet, not the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
Electrical Connection
This appliance must be installed by a qual i fi ed electrician
to comply with the relevant In sti tute of Electrical
Engineers (I.E.E.) regulations and also the local elec tric i ty
supply company re quire ments.
Make sure that the mains characteristics (voltage,
nominal, power, etc.) match the ratings indicated on the
data plate affi
xed to the lower right hand cooker upright
(remove storage drawer). The cooker is preset for a
single-phase earthed electrical connection. It is essential
to install a multi-pole circuit breaker that completely
disconnects the appliance from the mains, with a
minimum contact break distance of 3mm.
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance must be connected to an effi
cient
earthing circuit. If the electricity network is not equipped
with an earth connection, then it must be installed
separately in compliance with local regulations. Earthing
is a safety measure required by law, and must be
performed with particular care by a qualifi ed technician,
who must also check that the electricity supply
characteristics are correct.
The cable size used should be suitable for the appliance
load and in accordance with local regulations. Please
note the maximum cable sizes are 6mm
2
for the screw
terminals and 10mm
2
for the 3 pronged links.
Access to the mains terminal is gained by removing
the electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for your
electrical supply type (see fi g.).
Check that the links are correctly fi tted and that
the terminal screws are tight.
Secure the mains cable using the cable clamp.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
oc ca sion al ly cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
100mA device. This work should be carried out by a
qualifi ed electrician.
Oven Light
Press the oven light switch and check that the light is
working.
NB
The oven light bulb is not included in the guarantee
Hobplate
Turn on each plate in turn and check that it heats up.
Oven check
The clock must be set to the time of day before the
Multifunction oven will work.
Press and hold as above.
At the same time, press - or + until the correct time
shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn off
the power supply for a minute or two and start again.
Turn on the ovens. Check that the oven fan starts to turn
and that the oven starts to heat up. Turn off the ovens.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fi t each end keyhole over their respective
screws. Tighten the fi xing screws.
Refit the drawer
Rest the drawer back on the side runners and, keeping
it level, push it right back. The clips should click into
position holding the drawer to the side runners
Customer care
Please complete your contact details in the front of
this section. Please inform the user how to operate the
cooker and hand over the instruction pack.
Thank you.
Содержание Toledo XT Electric
Страница 1: ...110 Ceramic Electric Users Guide Installation Service Instructions U107230 01...
Страница 32: ......
