Rangemaster Toledo FS Hob, Инструкция по установке и эксплуатации, Страница: 17 / 24

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
13
Pressure Testing
The gas pressure can be measured at one of the hotplate
burner injectors (not the wok burner).
Lift off a burner head. Fit the pressure gauge to the injector.
Turn on and light one of the other hotplate burners.
Turn on the control knob for the burner with the pressure
gauge fitted to let gas through.
See the data badge for test pressures.
Turn off the burners. Make sure that you reassemble the
burner top in the correct way on the burner body.
Fixing the Hob
The hob must be sealed to the worksurface to prevent liquid
from infiltrating into the cabinet. A foam tape seal is supplied
with the hob.
Fit the seal as follows:
1.
Turn the hob over and place on a secure level surface.
2.
Detach the foam seal from the backing, checking that
the transparent protection still adheres to the seal itself.
Position the seal carefully along the edge of the hob.
Take special care in the corners, making sure there
are no gaps
(Fig.5-6)
. The ends of the strips must fit
together without overlapping.
3.
If the surface that the hob is to be fitted to is tiled or
is not reasonably smooth, additional sealing with a
waterproof silicone sealant may be required.
4.
Turn the hob back the right way up and position it
within the worktop cut-out.
5.
Using the brackets supplied, fix the hob to the worktop.
Make sure the tag fits into the slot on the hob base
(Fig.5-7) , then tighten the screw until it is locked to the
worktop.
Fig.5-6
Fig.5-7