Rangemaster Excel 110 G5 Induction, Руководство пользователя

Страница: 33 / 44

INSTALLATION
Check the appliance is electrically safe when you have finished.
29
ArtNo.010-0004 Moving the cooker
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig.7-5) .
Rotate the nut – clockwise to raise – counter-clockwise to
lower. Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (Fig.7-6) .
Carefully push the cooker backwards off the base tray.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it (Fig.7-7) .
n n
DO NOT use the door handles or control knobs to
manoeuvre the cooker.
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected,
make sure it is switched off at the supply switch before
gripping under the fascia panel and lifting the front of the
cooker slightly
(Fig.7-6)
. Check behind the cooker to make
sure that the electricity cable is not caught. As you progress,
always make sure that the cable has sufficient slack to allow
the cooker to move.
When you replace the cooker, check behind it again once
more to make sure that the electricity cable is not caught or
trapped.
Levelling the Cooker
Place the cooker in its intended position. Take care not
to twist it within the gap between the kitchen units, as
otherwise, damage may occur to the cooker or units.
There are two screw-down feet at the front and two levelling
rollers at the rear, which can be used to adjust the height and
level of the cooker.
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Fig.7-5
Fig.7-6
Fig.7-7