34
7. To
Remove
a
Thermostat
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Open appropriate oven door and
remove oven furniture.
RH oven
Remove thermostat phial cover (2 screws). Unclip
the thermostat phial from the clips in the oven
back.
LH oven
Pull cooker forward to gain access to the cover
box at the rear of the cooker. Remove the screws
securing the cover and lift clear.
Feed the thermostat capillary out of the oven.
Disconnect wiring from thermostat. Remove 2 screws
holding thermostat to mounting panel. Fit new
thermostat and reassemble in reverse order. Ensure
that the phial is clipped to the oven back with the
phial centrally positioned between the clips.
Check operation of thermostat.
8. To Change Grill Controller
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Disconnect wiring from controller.
Remove 2 screws holding controller to mounting
panel. Fit new controller and reassemble in reverse
order. Check for correct operation.
13. To Remove Grill Outer Door Panel
Open left hand oven door and remove 2 screws from
bottom edge of grill door. Open grill door, support grill
door outer panel and remove two screws from top
inner face of grill door.
Reassemble in reverse order.
14. To Remove an Oven Door
Open oven door and remove Handyrack (where
fi tted) by springing one side out of the bracket on the
door and sliding the other side free. Support the door
and remove the two screws securing the upper hinge
and packing to the cooker front. Remove the door
from the lower hinge by lifting slightly and moving
outwards.
Reassemble in reverse order.
15. To Change Oven Door Outer Panel
Remove the two plastic blanking plugs from the
door handles. Remove the 4mm Hex headed screws
holding the handle to the door with the hexagon key
tool. Remove two screws from top edge and two from
bottom edge of the door.
Remove outer door panel. Fit door handle to new
panel. Fit the plastic blanking plugs to the fi xing
holes.
The handles should be above the fi xings.
Fit panel to door. If replacing the outer panel on the
right hand door (with the Thermodial) take care to
make sure the sensor of the Thermodial is sealed to
the door by the rubber grommet.
Reassemble in reverse order.
16. To Change Oven Door Catch
Remove outer door panel (see 15). Remove screws
‘B’ holding catch assembly to inner door panel. Fit
new catch and reassemble in reverse order.
Check correct door operation.
Содержание ELAN U105510-01
Страница 1: ...110 Ceramic Users Guide Installation Service Instructions U105510 01...
Страница 38: ...38...
Страница 40: ......