Rangemaster Elan 90 Induction, Руководство пользователя

Страница: 35 / 40

35
SERVICING  WARNING
Disconnect from electricity supply before servicing. Check ap pli ance is safe when you have finished.
13. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook
is released. Proceed to the next hook and release it
in a similar way, and so on. Use force if the hooks are
stiff, as the old seal will be discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed round the door snapping in
each hook in turn.
14. To Adjust Main Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
15. To Remove Tall Oven Door
Open oven door, support the door and remove the
two screws securing the upper hinge and packing
to the cooker front. Remove the door from the lower
hinge by lifting slightly and moving outwards.
Reassemble in reverse order.
16. To Change Tall Oven Door Outer Panel
Remove oven door see 15. Lay door face down on a
suitable surface and remove 2 screws from bottom
edge of door and 2 screws from inside face of door.
Remove outer door panel. Remove door handle
by unscrewing 2 screws. Remove 2 cross-headed
screws holding door handle fi xing bracket to door
panel.
Fit door handle bracket and door handle to new
panel.
Fit panel to door. Take care to make sure the sensor
of the Thermodial is sealed to the door by the rubber
grommet.
Reassemble in reverse order.
17. To Change Tall Oven Door Magnetic Latch
Remove the control panel (see 4).
Remove the plinth (3 screws) and the central vertical
cover (5 screws). Prize the retaining clip off the
magnet unit. Fit new unit and retaining clip.
Reassemble in reverse order.
Check correct door operation.
18. To Remove Oven Inner Back.
Open the oven door. Remove oven furniture. For
the LH oven unscrew the 2 thermostat phial fi xing
screws.
Remove the fi xings that secure the inner back to the
oven rear.
Lift the removable panel away. Re-assemble in
reverse order. Ensure that the retaining fi xings
are fully tightened. For the LH oven unscrew the 2
thermostat phial fi xing screws. Remove the screws
that secure the inner back to the oven rear. Lift the
removable panel away. Re-assemble in reverse order.
Ensure that the retaining fi xings are fully tightened.
19. To Replace an Oven Fan
Disconnect from electricity supply.
Pull the unit forward to access the cover boxes at the
rear of the appliance.
Remove the fi xings that secure the cover and lift it
clear. Remove the fan wiring, noting the connection
positions. Remove the inner back as detailed in
Section 18. Hold the fan blades and undo the centre
nut (LH thread), brass washers and fan blade. Undo
the fi xings that retain the fan and remove it from the
cavity rear. Fit the replacement and re-assemble
parts in reverse order. Check that the oven operates
satisfactorily.