Rangemaster Classic 110 110 Dual Fuel FSD, Руководство пользователя и инструкции по установке

Страница: 24 / 32

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
22
Repositioning the Cooker following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.7-7), you need to check behind the cooker to ensure that
the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
With a stability chain fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
Conversion to Another Gas
If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions and see the instructions in the conversion kit.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the front
bottom corners of the cooker. To set the front turn the feet
bases to raise or lower.
Fitting the Handles and Handrail
Remove the 4 mm Allen screws from the doors (Fig.7-10).
Fit the door handles (Fig.7-11) and secure using the 4 mm
screws.
n n
The handles should be above the fixings.
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig.7-12). Fit the front handrail in position and secure
using the 4 mm screws.
Fitting the Splashback
The cooker can be installed with or without the supplied
splashback. To fit the splashback, first remove the two 3 mm
fixing screws and nuts on the rear of the grill flue. Hold the
splashback in position and refit the screws and nuts to secure.
ArtNo.210-0006 - Classic fitting the handles 2
Fig.7-11
ArtNo.210-0005 -
Classic - fitting the handles 1
Fig.7-10
ArtNo.210-0006 - Fitting the handles 3
Fig.7-12