Rangemaster Classic 100 Gas, Руководство пользователя и инструкции по установке

Страница: 22 / 44

18
ArtNo.320-0002a Proplus oven door side screws
Control Panel and Doors
Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can be used on the doors or, alternatively
using a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.
Glass Fronted Door Panels
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the ‘Moving the Cooker’ section under
‘Installation’ ).
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side (Fig. 6.10).
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
Note: The oven doors are triple glazed, the inner two panels
are fixed together and should not be separated. After
cleaning, carefully refit the outer door panel and replace the
side fixing screws.
n n
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
Ovens
Cleaning is easier if carried out while the oven is still warm.
Before cleaning, cover the burner to prevent the burner holes
becoming blocked.
The inside of the oven and inner door panel can be cleaned
using an approved cleaner (Table 6.1).
Take care not to disturb the oven thermostat temperature
sensor at the top of the oven opening (Fig. 6.11).
The enamelled oven burner trim (Fig. 6.12) can be removed
for cleaning.
The oven burner trim hooks onto the front of the oven burner
bracket. When refitting make sure that the trim is in the
middle of the front of the oven burner bracket (Fig. 6.13).
‘Cook & Clean’ Panels
The ovens have panels which have been coated with a special
enamel that partly cleans itself. This does not stop all marks
on the lining, but helps to reduce the amount of manual
cleaning needed.
The ‘Cook & Clean’ panels work better above gas mark 6
(200 °C). If you do most of your cooking below this
temperature, occasionally remove the panels and wipe with
a lint free cloth and hot soapy water. The panels should then
be dried and replaced and the oven heated at gas mark 6
(200 °C) for about one hour. This will make sure that the ‘Cook
& Clean’ panels are working effectively.
Do not use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
Thermostat temperature sensor
ArtNo.323-0009 - Bray burner shield fitted
Oven burner trim
ArtNo.323-00011 - Bray burner front shield
Fig. 6.10
Fig. 6.11
Fig. 6.12
Fig. 6.13