/Users/helix/MediaMorphosis/_RangeWard/Documentation/Manuals/Power Grazer Trailer Manual v9.docx
27
N:\S_Wp\Setups\Normal\Normal.dot
Fence Installation
1.
With One Person
. Tie Euibraid Rope to secure post with slip knot and slowly pull trailer
allowing reel to unspool rope. Park trailer at desired location, tension rope by tying rope
to trailer using insulated tie off located on left rear of trailer. Install and connect ground
rod. Securely connect red energizer wire to rope.
Caution Do not turn energizer on at this time
. Walk or drive back along line installing
posts about 50 feet apart. Undo slip knot and use insulated gate handle to attach rope to
exiting fence. Re-tension rope by moving several pig-tail posts slightly off line. Return to
trailer and turn energizer on.
2.
With Two People
. Tie Equibraid rope to secure post with slip knot. With post installation
assistant at the rear of the trailer and in a safe position to the side of the rope, the
operator of the pull vehicle (when safe to do so) slowly drives ahead allowing the reel to
unspool rope. The post installation assistant then walks behind the trailer at a safe
distance installing posts approximately 50 feet apart and installing rope into the pigtail
post. Park trailer at desired location, tension rope using insulated tie off located on left
rear of trailer. Install and connect ground rod. Securely connect red energizer wire to
rope with butterfly clamp. Turn energizer to ON position.
Caution At this point the rope has been electrified.
Return to start of the fence, pull insulated gate handle to release rope from post and
reconnect insulated handle onto existing fence using “dead end: or “power beyond”
feature.
Insulated tie off feature allows operator to tension rope and also keeps rope from inadvertently
energizing the trailer body.
