Rane MX 22, Руководство оператора

Страница: 3 / 11

Manual-2
INPUT LEVEL control and
indicators
This controls the overall level without
altering the relative settings of the Low and
High frequency Outputs. Input gain is +6 dB
at “10”. With signal applied, set this control
so the +4 dBu LED lights occasionally,
indicating sufficient signal. Flashing of the
OL (overload) LED during peaks can be
avoided by turning the INPUT LEVEL down.
LOW LEVEL control
This controls the level of signal going to the
LOW OUTPUT jacks. Unity gain is reached at
the “0 dB” mark with the INPUT LEVEL set
to “10”. This control does not affect the
MONO SUB OUTPUT level. Refer to Operating
Instructions on page Manual-6.
HIGH OUTPUTS
These are balanced Output jacks. Connect
the LEFT HIGH OUTPUT to the left channel
input of the high frequency amplifier, and
the RIGHT HIGH OUTPUT to the right
channel input of the high frequency
amplifier. When using different model
amplifiers for the low and high outputs, use
the amplifier with the most power for the
low outputs.
MONO SUB OUTPUT,
LEVEL trim, and
100 Hz FILTER switch
This Output contains the summed signals of
the LEFT and RIGHT LOW OUTPUTS. It may
be used instead of, or along with the LOW
OUTPUTS. The output may be adjusted with
the LEVEL trim from +6 dB to -10 dB. Unity
Gain is straight up at 12:00. Switch the 100
Hz FILTER to IN when using a subwoofer
along with the LOW OUTPUTS. This sends
only the very lowest frequencies to the
subwoofer.