REAR PANEL DESCRIPTION
1. INPUT Jack:
This is a ¼" TRS (Tip-Ring-Sleeve) jack which automatically accommodates either balanced or unbalanced
Input signals. For unbalanced operation, use a mono (single-conductor) shielded ¼" patch cord. For balanced operation, use
a two-conductor shielded cable wired to a stereo TRS ¼" male plug as in Rane Note 110 (supplied with this unit).
2. OUTPUT Jack:
This is a ¼" TRS (Tip-Ring-Sleeve) jack which delivers an unbalanced Output signal. Tip is “+” or “hot”,
ring is signal ground, and the sleeve is not connected. To drive unbalanced equipment, use a shielded mono patch cable.
3. GROUND LIFT Switch:
This switch provides the ability to separate chassis ground and signal ground. Normally, this
switch should be in the LIFT position. In some circumstances, moving it to the opposite position eliminates stubborn hum
and buzz problems.
If you are tempted to try moving this switch with your power amplifiers turned on and up, DON’T BE.
Always turn your
amplifier levels down before changing your grounds around
and then bring the level up slowly.
