R&S ZVA24, Руководство по обслуживанию

Страница: 376 / 606

Repairs R&S ZVA
1177.5333.02 3.68 E-11
Replacing the Coupler Unit (ZVA67)
(See Chapter 5, Spare Parts List, item 245 and drawings 1305.7002 and 1305.6241)
Opening the instrument and removing the coupler

Turn off the instrument and disconnect from the mains, screw off the 4 rear-panel feet (460) and
pull off the enclosure (400) backwards.

Remove the instrument base cover (297) after undoing the screws (299).

Disconnect the 3 RF cables and the bias cable from the coupler

Remove the 3.5mm connection cables (only with option ZVA24-B16).

Remove the frontcover

Remove the screws (182, 186, 202, 206) in the front of the instrument next to the port connector
and take out the coupler.
Fitting the new coupler unit and reassembling the instrument

Insert the coupler into the instrument and screw in the 4 screws (181, 186, 220).

Reconnect the 3 RF cables and the bias cable.

Fit the 3.5mm connection cables (only with option ZVA24-B16).

Fit the instrument base cover (297) and secure with 12 countersunk screws (299).

Push the enclosure (400) back on and screw the 4 rear-panel feet (460) into position.

Connect the mains cable, turn on at the mains switch and press the ON key.

Select Service Level 2 (see Service Functions).

When the instrument has been started, check the protocol file for errors:
[ INFO : Error Log ]

Record generator and receiver correction data (see Recording Correction Data ).

Perform factory system error calibration (see Factory System Error Calibration ).