Command reference
R&S
®
ZNL/ZNLE
567
User Manual 1178.5966.02 ─ 19
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
).
Usage:
Event
11.3
Common instrument commands
The following commands can be used independently of the active application(s).
Commands for remote instrument operation
.........................................................567
Selecting the operating mode and application
...................................................... 568
.............................................................................. 575
........................................................................... 602
11.3.1
Commands for remote instrument operation
The following commands are required to shutdown or reboot the R&S
ZNL/ZNLE from
a remote PC.
SYSTem:CLOGging
<State>
This command turns logging of remote commands on and off.
Parameters:
<State>
ON | OFF | 1 | 0
ON | 1
Writes all remote commands that have been sent to a file.
The destination is
C:
\Users\Public\Documents\Rohde-Schwarz\ZNL\ScpiLogging\
ScpiLog.<no.>
.
where <no.> is a sequential number
A new log file is started each time logging was stopped and is
restarted.
OFF | 0
*RST:
0
Manual operation:
See
SYSTem:REBoot
This command reboots the instrument, including the operating system.
Common instrument commands
