Remote Commands
R&S
®
ZNH
293
User Manual 1334.5985.02 ─ 02
SYSTem:POSition:GPS:QUALity?
This command queries the quality of the GPS signal.
Example:
SYST:POS:GPS:QUAL?
Usage:
Query only
SYSTem:POSition:GPS:SATellites?
This command queries the number of tracked satellites.
Example:
SYST:POS:GPS:SAT?
Usage:
Query only
SYSTem:POSition:GPS[:STATe]
<State>
This command turns the GPS receiver on and off.
Note that the GPS receiver only works if a connection between the R&S
ZNH and a
GPS signal transmitter is established.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
SYST:POS:GPS ON
Activates the GPS receiver.
SYSTem:POSition:LATitude?
This command queries the latitude of the current position of the R&S
ZNH.
Example:
SYST:POS:LAT?
Return value would be, for example, 48,7,40.0 for 48°, 7 ', 40.0"
in the northern hemisphere.
Usage:
Query only
SYSTem:POSition:LONGitude?
This command queries the longitude of the current position of the R&S
ZNH.
Example:
SYST:POS:LONG?
Return value would be, for example, 11,36,46.2 for 11°, 36',
46.2" East.
Usage:
Query only
SYSTem:POSition:VALid?
This command queries if the current position is valid.
Remote Control - Commands
