Getting Started
R&S
®
UPV
91
Getting Started 1146.2078.62 ─ 09
Numeric Display
●
Display of measurement results for measurement function selected in Ana-
lyzer Function panel
●
Display of measurement results for level monitor and/or input monitor
selected in Analyzer Function panel
●
Frequency measurement results, or frequency measurement result and
phase / group delay measurement result
Funct Ch1 to 2
Lev Mon Ch1 to Ch2
Input Ch1 to Ch2
Freq Ch1
Freq / Phase
These combo displays are extensions to the numeric measurement displays;
they show the respective numeric value plus the following:
●
Analog bar graphs
●
Limits
●
Minimum and maximum values
Sweep Graph 1 to 4
Impulse Response
FFT Graph 1 to 2
Waveform
PESQ/POLQA
Bar Graph 1 to 2
●
Up to four of each of these display windows can be opened (depending on
the window type) in order to display the scans of the different measurements
●
Graphical display shows one or two channels
●
The measurement results are displayed in the way defined in the associated
configuration panel
Dig Analyzer Protocol
●
The analyzed data of the digital audio protocol is displayed here (R&S UPV
K21 option (digital audio protocol))
3.3.6 Basic Rules of Operation
The following basic rules are intended to simplify operation of the audio analyzer:
●
Operating sequence in the panels from top to bottom
Changes to parameters of individual menu items may affect the selection or value
range of menu items which are usually located further down (they affect the selec-
tion or value range in fields located higher up in only a few exceptional cases).
●
Sequence Generator – Analyzer – Measured value display
Many setting parameters can be copied to other panels. For example, the sweep
frequency settings can automatically be adopted as the scaling for the graph.
3.3.7 Function Selection and Value Entry
All functions and parameters are set in the panels.
The rotary wheel is used for navigating inside the panels. Turning the rotary knob
clockwise moves the cursor down or to the right. Here the cursor first moves to the
right inside a field, then down through the current group, then jumps over to the right-
hand column, down again to the end of the group from where the cursor then moves to
the left-hand column of the following group, and so on.
As an alternative, the up/down cursor keys can also be used for navigating.
Brief Introduction to Operation