R&S SMJ100A, Руководство по эксплуатации

Страница: 746 / 874

Remote Control Commands
R&S
®
SMJ100A
730 Operating Manual 1403.7458.32 ─ 14
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:OPTimization[:RF]:STATe <State>
Activates/deactivates optimization of level accuracy and imbalance for RF Output.
Level accuracy and imbalance can be either optimized for RF output (active) or for dif-
ferential outputs (not active).
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
1
Example: IQ:OUTP:ANAL:BIAS:OPT:STAT ON
activates optimization for RF output.
Manual operation: See "Optimize I/Q Signals for RF Output" on page 302
[:SOURce<hw>]:IQ:OUTPut:LEVel <Level>
Sets the off-load voltage.
Single ended Output:
●
Value range: 20 mV ... 2 V EMF.
●
The maximum overall output voltage (
SOUR:IQ:OUTP:POW:PEP + SOUR:IQ:
OUTP:BIAS:I|Q
) is 3.7 V
Differential Output:
●
Value range: 40 mV ... 4 V EMF.
●
The maximum overall output voltage (
0.5 * SOUR:IQ:OUTP:POW:
PEP + SOUR:IQ:OUTP:BIAS:I|Q + 0.5 * SOUR:IQ:OUTP:OFFS:I|Q
) is
3.7 V
Parameters:
<Level> float
Range:
0.02 to 4
Increment: 0.001
*RST:
1
Default unit: V
Example: SOURce1:IQ:OUTPut:LEVel 2
sets a off-load level of 2 V
Manual operation: See "I/Q Level Vp (EMF)" on page 304
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:POWer:PEP:RESult?
Displays the resulting output off-load voltage of both signal components at the rear
panel.
SOURce Subsystem