R&S SMJ100A, Руководство по эксплуатации, Страница: 537 / 874

Remote Control Commands
R&S
®
SMJ100A
521 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Threshold> float
Range:
0.01 to 2
Increment: 0.01
*RST:
1
Default unit: Volt
Example: INP:BERT:THR 1 V
A high/low threshold of 1 volt is set at the BERT inputs. The sig-
nal is high (active) for a signal voltage of 1 volt and higher.
Manual operation: See "Threshold" on page 190
:TRIGger:BLER[:IMMediate]
:TRIGger:BERT[:IMMediate]
Triggers a single bit error rate or block error rate measurement if the single trigger
mode (
BERT|BLER:SEQ SING
) is selected.
Example: BERT:SEQ SING
selects the single trigger mode.
Example: TRIG:BERT
starts a single bit error rate measurement.
Usage: Event
7.6 CALibration Subsystem
The
CALibration
system contains the commands for adjustment. Adjustment is trig-
gered by the query commands. The response "0" indicates error-free adjustment, and
the response "1" means that an error occurred during adjustment.
:CALibration<hw>:ALL[:MEASure]?
................................................................................. 521
:CALibration<hw>:FMOFfset[:MEASure]?
.........................................................................522
:CALibration<hw>:FREQuency[:MEASure]?
......................................................................522
:CALibration<hw>:IQModulator:FULL?
............................................................................. 522
:CALibration<hw>:IQModulator:LOCal?
............................................................................523
:CALibration<hw>:LEVel[:MEASure]?
...............................................................................523
:CALibration<hw>:LEVel:STATe
...................................................................................... 523
:CALibration<hw>:LEVel:HACCuracy[:STATe]
.................................................................. 524
:CALibration<hw>:ROSCillator[:DATA]
............................................................................. 524
:CALibration<hw>:ALL[:MEASure]? [<Force>]
Starts all internal adjustments that do not require external measurement equipment.
Query parameters:
<Force> string
CALibration Subsystem