R&S SMJ100A, Руководство по эксплуатации, Страница: 451 / 874

Instrument Function
R&S
®
SMJ100A
435 Operating Manual 1403.7458.32 ─ 14
In the "Retrigger" mode, every trigger signal causes signal generation to restart. This
restart is inhibited for the specified number of samples.
This parameter is only available on external triggering.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit
on page 686
Marker Mode
Provides the settings necessary to define the marker output signal for synchronizing
external instruments.
Marker Mode
Marker configuration for up to 4 marker channels. The settings are used to select the
marker mode defining the shape and periodicity of the markers. The contents of the
dialog change with the selected marker mode; the settings are self-explanatory.
All regular marker signals are described in "Marker Modes" on page 324.
"Restart" A marker signal is generated at the start of the waveform.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE
on page 689
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider
on page 690
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 691
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern
on page 690
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime
on page 689
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime
on page 689
Marker Delay
The delay of the signals on the MARKER outputs is set in the"Marker Delay" section.
Marker x Delay
Enters the delay between the marker signal at the marker outputs and the start of the
frame or slot.
The input is expressed as a number of symbols. If the setting "Fix marker delay to
dynamic range" is enabled, the setting range is restricted to the dynamic range. In this
range the delay of the marker signals can be set without restarting the marker and sig-
nal.
Remote command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay
on page 688
Current Range without Recalculation
Displays the dynamic range within which the delay of the marker signals can be set
without restarting the marker and signal.
The delay can be defined by moving the setting mark.
Baseband Signal - Baseband Block