R&S SMJ100A, Руководство по эксплуатации, Страница: 702 / 874

Remote Control Commands
R&S
®
SMJ100A
686 Operating Manual 1403.7458.32 ─ 14
Manual operation: See "Trigger Delay" on page 434
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit <Inhibit>
Specifies the number of samples by which a restart is to be inhibited following a trigger
event. This command applies only in the case of external triggering.
Parameters:
<Inhibit> integer
Range:
0 to 67108863
*RST: 0
Example: BB:MCCW:TRIG:SOUR EXT
selects an external trigger
BB:MCCW:TRIG:INH 200
sets a restart inhibit for 200 samples following a trigger event.
Manual operation: See "Trigger Inhibit" on page 434
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
AUTO
The multi carrier signal is generated continuously.
RETRigger
The multi carrier signal is generated continuously. A trigger
event (internal or external) causes a restart.
AAUTo
The multi carrier signal is generated only when a trigger event
occurs. After the trigger event the signal is generated continu-
ously. Signal generation is stopped with command
SOURBB:MCCW:TRIG:ARM:EXEC
and started again when a trig-
ger event occurs.
ARETrigger
The multi carrier signal is generated only when a trigger event
occurs. The device automatically toggles to RETRIG mode.
Every subsequent trigger event causes a restart. Signal genera-
tion is stopped with command
SOURBB:MCCW:TRIG:ARM:EXEC
and started again when a trigger event occurs.
SINGle
The multi carrier signal is output only when a trigger event
occurs. After the trigger event the signal is output once to the set
sequence length (
SOURBB:MCCW:TRIG:SLEN
). Every subse-
quent trigger event causes a restart.
*RST:
AUTO
SOURce Subsystem