Remote Control Commands
R&S
®
SGT100A
413
User Manual 1176.8674.02 ─ 07
Example: Querying the status of the Create Waveform file process
The following is an example on how to use these commands to retrieve information
about how many percent of the initiated process are completed.
[:SOURce<hw>]:BB:PROGress:MCODer?
........................................................................413
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:MCARrier?
..........................................413
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:WSEGment?
.......................................413
[:SOURce<hw>]:BB:PROGress:MCODer?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:MCARrier?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:WSEGment?
Queries the status of an initiated process, like for example the calculation of a signal in
accordance to a digital standard, or the calculation of a multi-carrier or multi-segment
waveform file.
Return values:
<WSegment>
integer
Indicates the task progress in percent
Range:
0 to 100
*RST:
100
Example:
See
Example "Querying the status of the Create Waveform file
Usage:
Query only
11.14.8 SOURce:BB:POWer Subsystem
This subsystem contains the commands for retrieving the level values of the digital
baseband signal.
[:SOURce<hw>]:BB:CFACtor?
This command queries the crest factor of the baseband signal.
Return values:
<CFactor>
float
Range:
0 to 100
Increment: 0.01
*RST:
0
Default unit: dB
Example:
BB:CFAC
queries the crest factor of the baseband signal.
Usage:
Query only
SOURce Subsystem
