Remote control commands
R&S
®
RTA4000
603
User Manual 1335.7898.02 ─ 08
Parameters:
<Polarity>
POSitive | NEGative
*RST:
POS
17.10.6
Firmware update
DIAGnostic:UPDate:TRANsfer:OPEN
.............................................................................. 603
DIAGnostic:UPDate:TRANsfer:DATA
............................................................................... 603
DIAGnostic:UPDate:TRANsfer:CLOSe
............................................................................. 603
............................................................................................ 603
DIAGnostic:UPDate:TRANsfer:OPEN
<TransferItem>
Opens a data transfer for the firmware update file, and checks for errors.
Parameters:
<TransferItem>
FIRMware
Example:
See
Chapter 17.2.2.2, "Using DIAGnostic:UPDdate:TRANsfer"
DIAGnostic:UPDate:TRANsfer:DATA
<Offset>,<Checksum>,<Data>
Sends the firmware update file data to the internal RAM of the instrument
Setting parameters:
<Offset>
Specifies the byte offset of the blockdata in the file.
<Checksum>
CRC-16-CCITT type checksum calculated for the raw binary
data in blockdata.
<Data>
Block data is composed of a header #nm containing the length
of the data followed by the data in raw binary format. Here, m is
the length of the data in byte, and n is the number of digits in m.
Example:
See
Chapter 17.2.2.2, "Using DIAGnostic:UPDdate:TRANsfer"
Usage:
Setting only
DIAGnostic:UPDate:TRANsfer:CLOSe
Closes the file transfer.
Example:
See
Chapter 17.2.2.2, "Using DIAGnostic:UPDdate:TRANsfer"
Usage:
Event
DIAGnostic:UPDate:INSTall
<Path>
Starts the firmware update.
General instrument setup