Preparing for Use
R&S
®
NRX
14
Getting Started 1424.7070.02 ─ 04
4 = R&S NRP
‑
ZK8
5 = Sensor connector of the R&S NRX
6 = R&S NRX
Use an R&S NRP
‑
ZK8 cable to connect an R&S power sensor to the R&S NRX. If you
use an R&S NRP
‑
ZK6 cable, the reference clock and trigger are not supported.
1. 8
-
pin female connector of R&S NRP
‑
ZK8:
a) Insert the screw-lock cable connector into the host interface of the R&S power
sensor.
b) Tighten the union nut manually.
2. 8
-
pin male connector of R&S NRP
‑
ZK8:
a) Insert this connector into one of the sensor ports of the R&S NRX.
3. Connect the RF connector of the R&S power sensor to the signal source. For
details, see the user manual of the R&S power sensor.
Note:
Incorrectly connecting/disconnecting an R&S power sensor can damage the
power sensor or lead to erroneous results.
4.8.2
R&S
NRP
‑
Zxx
Connect the cable of the R&S
NRP
‑
Zxx power sensor to the one of the sensor connec-
tors of the R&S NRX.
4.8.3
R&S NRT-Zxx
Requires the sensor interface for R&S NRT (R&S NRX-B9).
Connect the R&S NRT-Zxx power sensor between source and load.
Connecting Power Sensors
