Instrument Tour
R&S
®
NRT2
27
Getting Started 1430.0573.02 ─ 03
5.2.2
Ethernet Interface
See (2) in
.
The Ethernet connector is an RJ45 socket for remote controlling the R&S NRT2
via a network.
5.2.3
USB Device Interface
See (3) in
.
USB
2.0 (universal serial bus) interface of the type B (receptacle). Used to con-
nect the R&S NRT2 to a computer for USB remote control.
5.2.4
USB Host Interface
See (4) in
.
See
Chapter 5.1.4, "USB Host Interface"
5.2.5
AC Supply and Power Switch
See (5) in
.
Observe the safety instructions in
When the R&S NRT2 is connected to the AC supply, it automatically sets itself to
the correct range for the applied voltage. The range is printed on the casing.
There is no need to set the voltage manually.
Further information:
●
Chapter 4.6, "Connecting to Power"
5.2.6
IEC 625/IEEE 488 Interface
See (6) in
.
Requires GPIB/IEEE488 Interface (R&S NRT2-B8).
IEC bus (IEEE 488) interface for remote control of the R&S NRT2. Used to con-
nect a controller to remote control the R&S NRT2. Use a shielded cable for the
connection.
Rear Panel Tour