Setting up a measurement
R&S
®
NRPM
44
User Manual 1425.8663.02 ─ 07
Setting up the RF frontend with the sensor module in an RF test chamber
Perform the following steps:
1. In the RF test chamber, mount the antenna modules.
2. On the interface module, dismount the strain relieve
using a torx
screwdriver TX8.
3. Connect each antenna module cable to the antenna module cable connectors
.
4. Mount the strain relieve of the interface module.
5. Connect the interface module with the sensor module (
6. Continue with
Setting up the connection to the controller PC
.
6.3.2
Setting up the connection to the controller PC
The controlling host of the R&S
NRPM OTA power measurement solution is a
computer, using a supported software for controlling the R&S
NRPM3(N) sensor
modules, see
Chapter 4.4, "Hardware and software requirements"
You can connect the sensor module using the LAN interface, when working with
the R&S
NRPM3N. To connect the R&S
NRPM3, use the USB host interface.
To establish a connection, see:
●
Chapter 6.3.4, "Using the LAN connection"
●
Chapter 6.3.3, "Using the USB connection"
Connecting an R&S
NRPM OTA power measurement setup