R&S NRP2, Руководство пользователя

Страница: 273 / 437

Remote Control - Commands
R&S
®
NRP2
255 User Manual 1173.9157.02 ─ 03
Parameters:
<lower_limit> float_value
Range:
-200 DB .. 200 DB
*RST: 0 DB
Default unit: DB
OUTPut:RECorder<[1]..2>:LIMit:UPPer <upper_limit>
Specifies the upper power limit of the characteristic for one of the two analog outputs (see
​
figure 6-8
​
Characteristic of analog outputs ). The unit corresponds to the output unit of the
measured value.
Value range: See
​
table 6-10
​
Value ranges, depending on the unit .
Unit:
​
table 6-11
​
Output unit of measured value of calculate block .
Parameters:
<upper_limit> float_value
*RST:
20 DBM or 10 DB
OUTPut:RECorder<[1]..2>:LIMit:UPPer:POWer <upper_limit>
Specifies the upper power limit of the characteristic for one of the two analog outputs if
the associated calculate block returns a power (unit
DBM
,
W
or
DBUV
) as the measured
value (see
​
figure 6-8
​
Characteristic of analog outputs ).
Unit: DBM | W | DBUV
Parameters:
<upper_limit> float_value
Range:
-120 DBM to 90 DBM
*RST: 20 DBM
Default unit: DBM
OUTPut:RECorder<[1]..2>:LIMit:UPPer:RATio <upper_limit>
Specifies the upper power limit of the characteristic for one of the two analog outputs if
the associated calculate block returns a power ratio (unit
DB
, DPCT or
O
) as the measured
value (see
​
figure 6-8
​
Characteristic of analog outputs ).
Unit: DB | DPCT | O
Parameters:
<upper_limit> float_value
Range:
-200 DB .. 200 DB
*RST: 10 DB
Default unit: DB
OUTPut