R&S NRP2, Руководство пользователя

Страница: 249 / 437

Remote Control - Commands
R&S
®
NRP2
231 User Manual 1173.9157.02 ─ 03
Table 6-11: Output unit of measured value of calculate block
CALC:MATH? CALC:REL:STAT OFF CALC:REL:STAT ON
"(SENSn)" DBM | W | DBUV DB | DPCT | O
"(SENSn-SENSm)" DBM | W | DBUV DB | DPCT | O
"(SENSn+SENSm)" DBM | W | DBUV DB | DPCT | O
"(SENSn/SENSm)" DB | DPCT | O DB | DPCT | O
"SWR(SENSn,SENSm)" O -
"REFL(SENSn,SENSm)" O -
"RLOS(SENSn,SENSm)" DB -
The value range depends on the current output unit of the calculate block's measured
value, as shown in
​
table 6-10
​
Value ranges, depending on the unit .
Parameters:
<value> float_value
*RST:
0 DBM or 0 DB
Default unit: See table referred to above.
CALCulate<[1]..8>:RELative[:MAGNitude]:AUTO <auto>
Sets the current measured value as the reference value. When used as a setting com-
mand, this command can only be called by the parameter
ONCE
.
OFF
will be ignored.
OFF
is always returned in response to a query.
Error messages:
-230 "Data corrupt or stale" : The current measured value is invalid.
Parameters:
<auto> OFF | ONCE
*RST:
OFF
CALCulate<[1]..8>:RELative:POWer[:MAGNitude] <value>
Has the same direct effect as
CALC:REL
on the reference value for measured values
that share the unit of a power.
Parameters:
<value> float_value, units: DBM | W
Range:
1e-18..1e18 W | -150..210 DBM
*RST: 0 DBM
Default unit: DBM
CALCulate (Configuration of Calculate Blocks)