Remote Control - Commands
R&S
®
NRP2
196
User Manual 1173.9157.02 ─ 03
The query form
*PSC?
reads out the contents of the power-on-status-clear flag. The
response can be 0 or 1.
Parameters:
<Function>
0 | 1
0
Causes the contents of the status registers to be preserved. Thus
a service request can be generated when switching on the instru-
ment, if the status registers ESE and SRE are suitably configured.
1
Resets the registers.
*RCL
<value>
R
e
C
a
L
l calls the device state which has been stored with the
*SAV
command under the
specified number. The effect of
*RCL
0 to 19 is the same as if one of the setups 0 to 19
had been selected in manual control.
*RCL
0 resets the device to the default state.
Parameters:
<Value>
1 to 19
Available recall numbers for device setups.
Usage:
Event
*RST
R
e
S
e
T
sets the instrument to a defined default status. The command essentially corre-
sponds to command
SYSTem:PRESet
and to pressing (PRE)SET.
The following table documents the difference.
SYSTem:PRESet
acts like the frontpanel
key (PRE)SET.
Table 6-1: Difference between commands *RST und SYSTem:PRESet
INITiate:CONTinuous
SENSe:AVERage:TCONtrol
*RST
OFF
REPeat
SYSTem:PRESet
ON
MOVing
The following table lists all preset values
Table 6-2: Preset values
Command
Preset and *RST value
Remark
CALC<[1]..8>:FEED[1..2]
"POW:AVER"
The calculate block processes
average power values ("Average").
CALC<[1]..8>:LIM:BEEP
OFF
No audible signal in case of limit
violations.
CALC<[1]..8>:LIM:CLE:AUTO
OFF
No automatic reset of the limit mon-
itoring function when a measure-
ment is started.
Common Commands to IEEE 488.2
Содержание NRP2
