R&S FSW Series, Руководство пользователя

Страница: 1269 / 1450

Remote Commands
R&S
®
FSW
1269 User Manual 1173.9411.02 ─ 43
[SENSe:]CORRection:TRANsducer:COMMent <Comment>
This command defines the comment for the selected transducer factor.
Before you can use the command, you have to select and turn on a transducer.
Parameters:
<Comment> *RST: (empty comment)
Manual operation: See "Comment" on page 681
[SENSe:]CORRection:TRANsducer:DATA {<Frequency>, <Level>}...
This command configures transducer factors for specific trace points. A set of trans-
ducer factors defines an interpolated transducer line and can be stored on the instru-
ment.
For details see Chapter 12.3.1, "Basics on Transducer Factors" , on page 675.
Parameters:
<Frequency> The unit for <Frequency> is Hz, which may or may not be omit-
ted. Frequencies have to be sorted in ascending order.
Default unit: Hz
<Level> The unit for <Level> depends on
[SENSe:]CORRection:
TRANsducer:UNIT
.
Example:
SENSe1:CORRection:TRANsducer:UNIT 'DB'
// Frequency Span 0 Hz to 4 Ghz
SENSe1:CORRection:TRANsducer:DATA 0,8,2GHz,5,4GHz,3
Creates the transducer points:
Manual operation: See "Data Points" on page 682
Frequency Level
0 Hz 8 dB
2 GHz 5 dB
4 GHz 3 dB
[SENSe:]CORRection:TRANsducer:DELete
This command deletes the currently selected transducer factor.
Before you can use the command, you have to select a transducer.
Example: CORR:TRAN:DEL
Manual operation: See "Delete Line" on page 680
[SENSe:]CORRection:TRANsducer:SCALing <ScalingType>
This command selects the frequency scaling of the transducer factor.
Configuring the R&S FSW