R&S 1311.6010K22, Руководство пользователя

Страница: 780 / 1611

GUI reference
R&S
®
ZNB/ZNBT
780 User Manual 1173.9163.02 ─ 62
5.18.4.1 Controls on the External Devices tab
The buttons in the "External Devices" panel open the following dialogs:
●
"Power Meters...", see Chapter 5.18.4.2, "External Power Meters dialog" ,
on page 780
●
"Power Meter Config...", see Chapter 5.18.4.3, "External Power Meter Config dia-
log" , on page 784
This button is active only if at least one external power meter is online (physically
connected, switched on, ready to be used).
●
"Generators...", see Chapter 5.18.4.4, "External Generators dialog" , on page 785
●
"Inline Cal Systems", see Chapter 5.18.4.5, "Inline Calibration Systems dialog" ,
on page 789
Switch matrices can be configured on the "External Ports" tab, see Chapter 5.18.5.3,
"External Matrices dialog" , on page 791 and Chapter 5.18.5.5, "Switch Matrix RF
Connections dialog" , on page 796.
Remote control via GPIB
To control external devices via GPIB, you have to use an Chapter 4.7.26, "USB-to-IEC/
IEEE adapter" , on page 265.
Log Errors
Enables the transfer of error messages for external devices (e.g. connection errors) to
the error log. The error log appears in the "Info" dialog; see
Chapter 5.18.1.3, "Info dia-
log" , on page 766.
Remote command:
n/a
5.18.4.2 External Power Meters dialog
The "External Power Meters" dialog configures external power meters so that they can
be used for measurements and power calibrations.
Access: System – [Setup] > "External Devices" > "Power Meters..."
Setup softtool