LM05 SERIES II I&M MANUAL/EN/11.30.2010
31/89
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
Figure 12. Chain Dimensions
11 t
t
t
P25004
Ød
Measure the following chain dimensions at several points on chain: (
Figure 12
)
Dimensions of one link ( d x t ) where, d = diameter and t = pitch
Length over 11 links ( 11 t )
Replace load chain if any one of these dimensions exceeds maximum allowed wear.
Maximum allowed wear:
Minimum link diameter allowed
(d):
0.1693” [4.30 mm] MINIMUM
Maximum pitch allowed
(t):
0.5157” [13.10 mm] MAXIMUM
Maximum length allowed (11t):
5.5216” [140.25 mm] MAXIMUM
NOTICE:
If load chain needs replaced, then inspect chain guide and chain (load) wheel on hoist
and idler sprocket in 2-fall load block for excessive wear. A chain sprocket showing
evidence of scored pockets or sharp edges generated from wear SHALL be replaced. A
worn chain sprocket or idler sprocket can greatly reduce the life of load chain.
