R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
- 6 -
Page | 6
SIE BENÖTIGEN FOLGENDES WERKZEUG
3mm A/F Inbusschlüssel
Schraubensicherung z.B. Thread Lock (Blue)
MONTAGEANLEITUNG
Montieren Sie die Klemmplatte über dem Fuß des Seitenständers. Die Versenkungen nach
oben.
Nehmen Sie die Grundplatte und montieren Sie sie an der Unterseite des Seitenständerfuß.
Eine kleine Menge (einen Tropfen) Schraubensicherung (blau) am Ende des
Schraubengewindes der drei Schrauben anbringen.
Die drei M5 Schrauben, die die zwei Platten in Position zusammenklemmen, nun anbringen
und am Seitenständer fixieren.
Ziehen Sie alle Schrauben fest und überprüfen Sie, dass die Kette nicht von der Auflagen-
Verbreiterung berührt wird, wenn der Seitenständer eingeklappt ist.
Bei der Montage an älteren Seitenständern, die etwas abgenutzt sind, den Polstersteifen in der
Grundplatte anbringen, um die Passform zu verbessern.
AUSGABE 1 23/10/2017 (AR)
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their
performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to title) has
been given or will apply to the Products other than those in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable
quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free
of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the
Products. On return of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or if the defect arises from
accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or
consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer’s statutory rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct from us (customer
must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G. All returns are subject to a 25%
restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns
of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
