Page
10
of
24
LP0264
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
•
Fit one length of heat shrink (Item 11) over each pair of indicator wires and heat with a
hot air gun or hair dryer to neatly hold and protect the wires.
•
To assemble your R&G tail tidy with mini indicators, you will need to use the indicator
adapter plates (item 6) included with the kit. Thread one spacer over the indicator wire
with the larger surface against the indicator body.
•
Thread the wire and indicator spacer through one indicator mount on the tail bracket.
Thread the second indicator adapter plate over the exposed wire so both raised plastic
bosses sit into the tail bracket as shown in the assembly diagram on page 2.
•
Sandwich the tail bracket with another indicator adapter, ensuring both raised faces sit
into the bracket mount, and secure in place using the locking nut provided with the
indicator. Do NOT overtighten.
•
Thread one indicator wiring cover (item 8) over each pair of indicator wires (a small
amount of lubricant or washing up liquid will help with this)
•
The assembly should resemble that shown in picture 15.
•
Connect 2 x CON0009 (item 9) connectors to the corresponding wires of the R&G mini
indicators using the following colour code:
o
Black
–
Black
o
Yellow
–
Black
•
If using RGR0002 Resistors they should be connected at this point using the colour chart
below:
o
Yellow
–
Yellow
o
Black
–
Black
Licence plate illuminator
•
Once indicators are fitted, the licence plate illuminator (item 2) can be assembled and
fitted to the Tail bracket (item 1)
•
The shroud provided should be fixed to the light using a small amount of superglue as
shown in picture 16, the purpose of this is to direct the light onto the plate once fitted.
•
Fit one length of heat shrink (Item 11) over the red and black wires and heat gently with
a hot air gun or hairdryer to neatly hold and protect the wires.
•
Place the threaded sections of the licence plate illuminator through the mount holes on
the rear of the tail bracket with the light side facing down.
•
To protect the wires on the underside of the tail bracket, place the number plate light
guard over the exposed threads on the inside of the tail bracket with the flat section
facing downwards, as shown in picture 17.
•
Using your ratchet and 6mm socket, fasten this assembly using the two washers and
nuts provided with the light assembly.
•
Connect one of the provided CON0009 (item 9) wiring connectors to the corresponding
bullet connectors of the light.
Fitting Assembly to bike
•
The tail bracket is now ready to be offered up to the bike, first, thread the wires through
the opening in the LHS of the bike where the OEM wires were originally removed.
•
Carefully lift the tail bracket assembly up to the 4 mounting holes on the underside of the
tail unit while pulling the wires into the space under the pillion seat.
