Please note that in cases where kits are packed with rubber washers holding the components onto the bolt –
the rubber washers should be thrown away
!
TOOLS REQUIRED
3mm metric Allen key.
Left-hand side (as you sit on bike)
Fit the counter sunk headed bolt through frame insert so head sits into the counter-sink.
Place the special nut on exposed end of bolt so the tapered face goes into the tapered recess.
Tighten bolt until tapered portion of nut just contacts tapered face of plastic frame insert.
Place the assembly into spindle in the position shown above with recess horizontal as shown
above.
Tighten bolt so frame insert is held in position firmly (do not over tighten).
Place bubble sticker as shown above.
Regularly check to ensure frame insert remains tight.
