5
piece of cloth for several minutes on the purpose of removing any residue on the soleplate.
NOTE:
It is normal that strange odor comes out from the unit for the first use. This will cease
after a short while.
OPERATION
1. Before filling water, make sure that the appliance is unplugged and the steam knob is set at
off position.
2. Open the water inlet cover, tilt the iron backwards at an angle of 45 degree to the horizontal
（
see Fig.1
）
, and fill proper water into the tank by a measuring cup.
After filling, close the cover.
Note:
1) Do not fill the water tank above the MAX level.
2) Do not put the perfume, vinegar, starch, descaling agents, ironing aids or other
chemicals in the water tank.
3) If the tap water in your area is very hard, we advise you to mix it with
an equal amount of distilled water or to use distilled water only.
3. Plug the iron into a standard wall outlet. Turn the temperature dial to your
desired setting, which is depended on the fabric of the garment. And the light
illuminates. Then put the iron on its heel.
（
see Fig.2
）
.
4. Once the soleplate reaches the preset temperature, the light will be off, then set
the steam knob to your desired steam output or dry position (off) and start ironing with
steam or without steam. Never touch the hot soleplate at any time during ironin
g！
5. Press the spray button a couple of times to moisten the laundry if necessary. Before
spraying, make sure there is enough water in the tank.
6. Burst steam button had better be used at maximum temperature, as it helps remove
stubborn creases. Wait a while before using the Burst steam button again to avoid
Fig.1
Fig.2
