• Sensor units are ceiling mounted and intended for indoor use only. Ensure a risk
assessment has been carried out and all reasonable safety precautions are in
place before commencing work.
• Call Points must be securely fixed, with the antenna upright, to a robust vertical
surface such as a wall or trolley. Where the existing surface is unsuitable for direct
fixing, use backing board such as plywood or similar sheet material.
• Each unit should be securely mounted using its two integrated mounting points
with M4 x 50mm pan head screws and wall plugs or other fixings selected for the
particular wall or ceiling type.
7. CONNECT - Test the System
• After installation of the units, it is essential to perform a system alarm test to
confirm proper operation of the system. It is also best practice to conduct a full
system test on a weekly basis. This test should also be performed following any
significant change to the site environment (new structure, wall or construction
equipment installed) that may affect the network signal.
• The System Test is started from the Tests selection via the CONNECT Main
Menu
• From the Test Menu, select System Tests to start test mode
• The CONNECT unit will display a confirmation message that the test has started.
Walk the site to check all units in the network.
• During System Test mode, the WES
3
network isolates all devices in the network,
